Crocodile Epoxy Plus

Crocodile Epoxy Plus : Excellent high bond strength tile adhesives and grouts. It is best for high cleanliness and durable areas such as glass mosaic, resin mosaic, green marbles, natural stones, moisture sensitive materials. This product can install on any surface is concrete, brick walls, old tiles, metal sheet, glass, fiber glass. It is good for areas cleaned by chemicals such as in hospitals, pantry, kitchen, exterior usage, factory, bathroom, swimming pool. Good for health.

Installation
Joint width should be between 2-6 mm (wall) 2-12 (floor)and depth should not be less than 2/3 of tile thickness. Recommend to apply tile grout 48 hours after tile installation.

Preparation
Clean and remove any dirt or contaminations remaining in the joints. Make sure the joints are clean and dry before grouting.

Mixing Ratio
Part A 1 Bag : Part B 1 Bag (Resin 4 : 1 Hardener by weight)

Mixing
• Mixture should be done within one use. Separate mixture is not advised, and the mixture should be used within 20-30 minutes (depending on temperature).
• Mix the 2 components together and mix well by hand or low speed drill (<150 rpm)for at least 1 minute by either squeezing out B until very little is left as much as possible.
• Leave the mixture for 5 minutes for chemical curing and stirred the mixture once again, before applying.

Application
Tiling
• Apply Epoxy Plus on the surface by using a flat side of a trowel. The thickness of Epoxy Plus is approximately 2-3 mm for mosaic tiles and 4-6 mm for ceramic tiles.
• Using an appropriate notched trowel (60° angel), comb Epoxy Plus uniformly in a ridged pattern.
• Lay tiles on Epoxy Plus and press firmly with rubber hammer.
•Keep a minimum of 3/4 of the joint depth available for grouting. Clean off any excess adhesive from surface, tile joint, and trowel within
20-30 minutes (depend on temperature).
• Wait for 48 hours before grouting.

Limitations
Tiling
• Do not tiling on rubber surface.
• For tiling light colored marble or stone, use white Epoxy Plus.
• Do not tiling in the areas subject to vibration such as heavy machine.
• Do not tiling in the area with temperature lower than 16°C and higher than 35°C

Grouting
• In case of grouting porous or rough-surface tile, test in an inconspicuous place first.
•Do not recommend grouting in the area with temperature lower than 16°C and higher than 35°C. Not appropriate for the area temperature exceeding 100°C
• Grouting only a small area (1 to 2 m2) at a time.
• While cleaning Epoxy Plus from the surface of the tile, change sponge frequency.
• Ready to fill water in the pool after applied 7 days.

Caution
• May be harmful to the eyes, skin, or lungs. Wear suitable protective clothing, gloves, and eye/face protection.
• In case of contact with eyes, rinse immediately with water and seek medical advice.
• After contact with skin, wash immediately with water.
• Keep out of reach of children.

Storage
• It should be kept in a dry place and the temperature is not too high to avoid product’s degradation.
• Use within 1 year from the date of manufacturing.

Packing
Net weight : 2 kg / Set (Part A 1,600 g : Part B 400 g)