Instruction

Substrate Preparetion

• Clean the surface to be free from dust, grease, concrete scrap or unknown matter etc.
• Fill cracks if any on the surface with suitable repairing material. Fill wall border or joints with sealant.
• The concrete surface must be damp but with no wet sheen on the surface.

Mixing

• Mix Crocodile Flex Shield with water 2.5 kg per 1 liter
  (Cement: Water = 2.5-2.7: 1 by volume). Allow mixture to
  sit for 5 min. Prepare only as much as can be applied
  within 1 hour period.

Application

1. Apply with brush or roller when a smooth finish is required 2 coats.
2. The second coat should be applied, allowing 30-90 minutes apart between each application.
3. When finished, surface should be left to dry for at least 3 days.
4. Tile work should be done on surface after 3 days.
5. Depend on temperature and relative humidity conditions on site. Normally will require a minimum of 7-14 days depending on ventilation. Ensure that the product has cured enough to be in permanent contact with water.

Estimated Coverage
1-1.5 kg/sq.m/ 2 coats

Caution

• Cement may cause injury to skin or eyes. Use of rubber gloves, dust masks, eye protection, and other safety equipment is recommended.
• If contact with eyes occurs, flush immediately and repeatedly with water, and then contact doctor immediately.
• Avoid contact with skin. Wash thoroughly after handling.
• Keep out of reach of children

Storage
It should be kept in a dry place and the temperature is not too high to avoid
product’s degradation. Age of product is 1 year.